Wednesday, April 13, 2011

Color Block Ruffle Fabric Option

Photobucket


COLOR BLOCK RUFFLE FABRIC SKIRT

This skirt always turns out cute! The hardest part is deciding your color combinations. There are so many possibilities. This is a great project for leftover fabrics- we try not to waste any fabric!

First, determine the colors and number of RUFFLES of each color block to be used to add up to the desired finished length. For the skirt shown our finished length was 11-12 inches- we had 4 sections of the skirt, with 3 ruffles in each section.


It is helpful to notice the knit fabric behind the ruffles- with the 1" ruffles, there are two strips behind the ruffles- one is opaque and one is more sheer. The line between these two strips is a nice straight line to follow when cutting.


Starting with the color block closest to the elastic top, cut half way between ruffles for the very top of the skirt.

Photobucket

Top of skirt


Now, cut your first section, cutting right up to the next ruffle- leaving both the opaque and the sheer strips of fabric intact. Repeat for all sections: for the second section, the top of the section should be cut between the ruffles and the bottom should be cut right up to the next ruffle - leaving both the opaque and sheer strips behind the last ruffle intact. For example, our second section was 3 ruffles- we cut right before the 4th ruffle. You will need both strips to overlap and zigzag the next color block series to join them together.


Photobucket

Bottom of color block section- with both strips intact and attached to color block.


Photobucket

Second section- 1 strip on the top and both on the bottom.


Repeat with the other color block ruffle sections. On the top, you will only need one strip, but at the bottom you will need both in order to overlap them and zigzag them together. You may have to cut off ruffles in order to give you the right amount of knit fabric... don't worry, you can use the ruffles for accessories or embellishments- (the tank top shown in the example uses 2 leftover ruffles).


Photobucket
Color block section- showing the knit fabric needed for joining the sections.

Photobucket

Cut off ruffle to be used for accessories later on!

Lay your color block sections out and re-measure.
Photobucket
Finished length will be 12"

JOINING COLOR BLOCK SECTIONS
Overlap the bottom of the first section with the top of the second section. Which fabric goes on top when zigzagging? Use the one that matches the thread you are using so that you will not have to change threads with each color block layer.

Photobucket


Photobucket

Photobucket
Zig-zagging the ruffle fabric sections.

Repeat for all layers.
Photobucket

Join the skirt as described in the Gathered Skirt Tutorial.

Photobucket

Tuesday, April 12, 2011

Gathered Ruffle Fabric Skirt with Elastic Waistband

This is our most requested pattern. There are several ways to complete a gathered skirt with elastic waistband. This is the way we do it. We have written very detailed directions but please don't be scared off- it is really quite simple. The fabric really turns this simple design into a fun and flirty skirt.

The first consideration in making the skirt is how you’d like it to fit and where the waistband will be worn. Some like the skirt to sit a little lower towards the hip rather than tight around the waist. In this example we are using two different fabrics for the skirt. The directions for the skirt portion is found in the Color Block Ruffle Fabric Tutorial.

Photobucket

Ruffle fabric & elastic



FIGURE TWO MEASUREMENTS

Many professionals suggest deducting one-half to one inch from the waist measurement so the elastic fits nice and snug. (This is especially important when using our 3” elastic. We deduct a full inch.) If when the measurement is taken, the tape is pulled snug, no deduction is taken. Because we overlap the ends of the elastic to sew it together, add 3/4" or so.



Photobucket

Our waist measurement for this skirt was 19.5 inches- we cut the elastic 20.5 inches


The length measurement is taken below the elastic to the desired length. Some prefer above the knee, some below. When using 2” RUFFLES the length needs to be flexible—an inch longer or shorter. Because we cut between the 2” RUFFLE, the length is usually an even number. (When using the 3” elastic, we opt for a shorter length because the skirt slips down slightly, even when the elastic fits snugly.)


We also consider the hip measurement (for adult-sized skirts) to determine if the full width of the ruffle fabric being used will allow the skirt to drape nicely in the back- we would not want the gathered skirt to be tight around the bottom. (This is also a consideration in determining the length of the skirt. Will it be too short in the back after draping over the buttocks?


For infant sizes up to 5-6 toddler sizes, we use approximately 36 inches of the RUFFLE width, leaving 12” or so for another project (embellishments, etc). It is an individual preference how much fullness or how many gathers to put into the skirt. In some instances, with a large adult waist size, we have used a number of inches from an additional width of ruffle fabric, adding to the full width of the fabric.


CUTTING

If uncertain, cut the skirt one extra RUFFLE longer. It can easily be trimmed off at any time during or after the skirt is completed.

Decide which cut end will serve as the top of the skirt. (See note for sewing with Cotton Candy 1” RUFFLES and Candy Cane 1” RUFFLES.) There is no need to hem the bottom of the skirt as it will not fray. But if you desire to serge, it will add a little weight to the bottom of the skirt.


ELASTIC

We like to serge the ends of the elastic and apply a drop of Fray Check to the ends of the threads. Set it aside to dry. (optional step)

Photobucket


After fray check dries, trim the thread on the elastic.

Photobucket


Stitch elastic ends together, reinforcing at both edges.

Photobucket

Stagger the ends to reduce bulk in finished elastic


Turn right side out, then stitch 1/4” from seam (stitching down the seam allowances), then again, 1/4” away from the first seam line.

Photobucket

First seam on right side of elastic

Photobucket

Second seam 1/4" away from the first


Photobucket

Finished elastic, wrong side showing


Photobucket

Finished elastic, right side showing



SEAMING THE SKIRT

We have found this to be the fastest, easiest way to sew the skirt together. The seam becomes the SIDE rather than the back of the skirt.

Serge off (or baste) the right selvage so that it holds the RUFFLES in place. Then after determining how much of the width to use, serge on the wrong side of the RUFFLES, which holds the RUFFLES in place on the left side.

Photobucket

Make sure all ruffles are facing down when serging (or basting). This will hold all the ruffles in place for the next steps.


Place right sides together, matching RUFFLES. Using the lines on the wrong side of the fabric, pin the fabric together.

Photobucket


If the lines match, the RUFFLES on the right side will be perfectly (or nearly) matched. Serge off the previously serged edges of both sides as you seam the skirt together.

Photobucket



Photobucket

Finished side seam

GATHER THE TOP OF THE SKIRT

There are several ways. If you have a serger and have not yet used your serger to gather your RUFFLE FABRIC, you may want to check with the manufacturer to see if you can increase the tension, lengthen the stitch and change the differential to allow gathering. Another way to gather the top is to sew a long stitch, then pull the top thread to gather the FABRIC. Or zigzag over a heavy thread (dental floss even works!), then secure one end and pull the other to create gathers.

Photobucket

zigzagging over thick thread (dental floss shown here)


TAILOR TACKS

Divide the elastic into fourths and mark with a single thread. Repeat with the gathered top of the skirt. Match the two seams, then half mark, the fold to find and mark quarters.

Photobucket


Bring the tacks from the elastic to the corresponding ones on the skirt top.

Photobucket


Adjust gathers to fit elastic, and pinning with the point up to the top of the elastic. (Take care to prevent the RUFFLES from catching on the pins!) The elastic will line up at the top of the RUFFLE (Note exception for 1” Cascading Brown, Pink and Yellow with White Dots).


Photobucket

Photobucket

STITCHING ELASTIC TO SKIRT

Professional/industrial Cover Stitch machines deliver a flawless dual seam to join the elastic and skirt together. You can create a similar finished product by using a twin needle.


Using a twin needle, the top of the waistband will have two adjacent rows of stitching. The underside has a zigzag stitch which allows the elastic to stretch without breaking or popping the stitch. Twin needles come in various widths. You will need to explore which widths are compatible for your sewing machine. We use the 4.0 or 6.0 (the 6.0 makes the parallel stitches further apart than the 4.0). When sewing over the seam of the elastic and skirt, it may be necessary to “walk” the machine over the multiple layers by moving the wheel by hand to prevent skipping stitches.

Photobucket


Photobucket


FEW NOTES:

CANDY CANE AND COTTON CANDY RUFFLE FABRICS – have a definite one way design to allow the RUFFLES to cascade, showing the fine colored edge beautifully. Cut the fabric one RUFFLE longer than the desired length of the skirt, then trim the top RUFFLE, leaving both parts of the fabric between RUFFLES, the opaque strip and the sheer strip. Both parts are needed to allow enough room to gather and attach the elastic.


BROWN, PINK, AND YELLOW POLKA DOT 1” RUFFLE FABRICS – When attaching elastic to skirt, we drop the elastic down slightly (about 1/8”) to cover the portion that is not colored, otherwise there is a white strip between the elastic and the beautifully colored design of the fabric.